ESU LokPilot 5 Micro 6-Pin DCC Decoder with wire tails

ESU LokPilot 5 Micro DCC 

6-pin plug in with wire tails. Can be used as a hard wired decoder by cutting the plug off and soldering the wires directly into your loco. There is also a version with a 6-pin plug directly on the decoder, i.e. without the wire tails in between.

Small footprint of only 8.0mm x 7.0mm x 2.4mm (on the capacitor 2.9mm) for Z Gauge, N Gauge and TT gauge.

Supports DCC, Märklin® braking sections, ZIMO® HLU braking commands and Lenz® ABC system

Braking with DCC brake modules or with DC voltage is also possible and can stop with a Selectrix® brake diode

Features:

• 14 - 128 speed steps
• 2 or 4 digit addresses
• 4 amplified function outputs, 180mA output / 2 logic level outputs   [6/8 pin]
• Up to 32 function triggers
• Lighting functions with independent brightness adjustment
• Analogue DC support
• 10 - 50 kHz PWM motor pulse frequency for silent operation
• Auto tune function for motor calibration
• 0.75A Max motor current 
• PowerPack compatible to bypass dirty track sections
• Overload protected motor/function outputs