Doehler & Haass PD10MU-3 DCC Decoder

Doehler & Haass PD10MU-3 wired DCC Decoder

DCC locomotive decoder PD10MU-3 with 6 connecting wires, 145mm in length.

A new Doehler & Haass decoder, adapted to the needs of N-gauge model railroaders. As with all comparable Doehler & Haass decoders, the driving characteristics of this decoder are at an excellent level. Two small capacitors are installed on the decoder for driving without data loss. Both the software and the chip itself correspond to the same modern technology as the latest decoders from Doehler & Haass. The decoder, produced in Germany, can be used for both normal DC motors and coreless motors. Switching from analogue to digital operation takes place automatically.

These loco decoders support braking with asymmetrical digital voltage (four diodes in series and one diode anti-parallel, Lenz ABC), slow travel (with suitable braking modules) and bidirectional communication (locomotive address feedback in DCC operation, RailCom®).

Technical specifications:

• Dimensions: 8.5 x 11.7 x 1.8mm
• Total load capacity: 1.0 A
• Maximum Motor Current: 1.0A
• Maximum driving voltage: 30 V
• Light function outputs: LV, LR (dimmable): 150 mA each
• Function outputs: AUX1, AUX2 (dimmable): 300 mA each

Functions

• For operation with conventional DC traction device, digital systems according to the NMRA standard (DCC)
• Switching between analogue and digital operation is automatic
• Short addresses (1-127), long addresses (0001-9999), with 14, 28, 126 speed steps
• Latest generation load control, resulting in particularly smooth control behavior
• Various control variants for optimum adaptation to the engine
• Internally 127 speed steps
• Adjustable motor frequency (low frequency, 16 kHz, 32 kHz)
• Block section operation with simple diodes in digital operation
• Light and function outputs (partially) dimmable and can be activated analogously
• Shunting gear
• Motor, light and track connections can be exchanged electronically
• All function outputs freely programmable
• Temperature protection
• Reset function for DCC
• The decoder can be updated
• Timer for switching off AUX1 and AUX2

These loco decoders support braking with asymmetrical digital voltage (four diodes in series and one diode anti-parallel, Lenz ABC), slow travel (with suitable braking modules) and bidirectional communication (locomotive address feedback in DCC operation, RailCom®).